如何在u-boot上启用RNDIS小工具

Question

我使用stm32mp157c-dk2板，并将RNDIS小工具添加到配置文件中。当我在主板上运行u-boot时，我得到“找不到以太网”。这是引导的日志：

U-Boot SPL 2018.11-stm32mp-r2.1-00026-g161ca183f1-dirty (Jan 31 2020 - 12:34:38 +0200)
Model: STMicroelectronics STM32MP157C-DK2 Discovery Board
RAM: DDR3-1066/888 bin G 1x4Gb 533MHz v1.41
Trying to boot from MMC1


U-Boot 2018.11-stm32mp-r2.1-00026-g161ca183f1-dirty (Jan 31 2020 - 12:34:38 +0200)

CPU: STM32MP157CAC Rev.B
Model: STMicroelectronics STM32MP157C-DK2 Discovery Board
Board: stm32mp1 in basic mode (st,stm32mp157c-dk2)
Board: MB1272 Var2 Rev.C-01
DRAM:  512 MiB
Clocks:
- MPU : 650 MHz
- MCU : 208.878 MHz
- AXI : 266.500 MHz
- PER : 24 MHz
- DDR : 533 MHz

*******************************************
*   WARNING 500mA power supply detected   *
* Current too low, use a 3A power supply! *
*******************************************

NAND:  0 MiB
MMC:   STM32 SDMMC2: 0, STM32 SDMMC2: 1
Loading Environment from EXT4... OK
In:    serial
Out:   serial
Err:   serial
Net:   No ethernet found.
Hit any key to stop autoboot:  0
Boot over mmc0!

你有什么意见建议？感谢你的帮助！

Answer 1

关于电源太小的警告是第一件要看的事情。电力不足往往会导致SoC的不是所有块都在使用/可用。