依赖关系问题-保持未配置

Question

这就是我试图在Ubuntu18.04中安装git时得到的结果。我可能反复问过一个问题，但我没有得到任何解决办法。

kcn@kcn-UBUNTU:~$ sudo apt-get install git
Reading package lists... Done
Building dependency tree       
Reading state information... Done
git is already the newest version (1:2.17.1-1ubuntu0.3).
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
3 not fully installed or removed.
Need to get 0 B/7,732 B of archives.
After this operation, 0 B of additional disk space will be used.
Do you want to continue? [Y/n] y

dpkg: error processing package libavahi-glib1:amd64 (--configure):
 package is in a very bad inconsistent state; you should
 reinstall it before attempting configuration

dpkg: dependency problems prevent configuration of geoclue-2.0:
 geoclue-2.0 depends on libavahi-glib1 (>= 0.6.16); however:
  Package libavahi-glib1:amd64 is not configured yet.

No apport report written because the error message indicates its a followup error from a previous failure.
                                                                                                          dpkg: error processing package geoclue-2.0 (--configure):
 dependency problems - leaving unconfigured

dpkg: dependency problems prevent configuration of libgeoclue-2-0:amd64:
 libgeoclue-2-0:amd64 depends on geoclue-2.0 (= 2.4.7-1ubuntu1); however:
  Package geoclue-2.0 is not configured yet.

dpkg: error processing package libgeoclue-2-0:amd64 (--configure):
 dependency problems - leaving unconfigured

No apport report written because the error message indicates its a followup error from a previous failure.


Errors were encountered while processing:
 libavahi-glib1:amd64
 geoclue-2.0
 libgeoclue-2-0:amd64
E: Sub-process /usr/bin/dpkg returned an error code (1)

我试着做以下几件事：

kcn@kcn-UBUNTU:~$ sudo apt-get install git

kcn的sudo密码： E: dpkg被中断了，您必须手动运行'sudo配置-a‘来纠正问题。

所以我打字

kcn@kcn-UBUNTU:~$ sudo dpkg --configure -a
................

................

dpkg: error processing package libavahi-glib1:amd64 (--configure):
 package is in a very bad inconsistent state; you should
 reinstall it before attempting configuration

Answer 1

试试这个：

sudo dpkg --configure -a
sudo apt-get -f install
sudo apt install libavahi-glib1 --reinstall

sudo dpkg --configure -a

指示dpkg“修复”自身。

sudo apt-get -f install

这将指示apt-get纠正依赖关系，并继续配置包。

sudo apt install libavahi-glib1 --reinstall

重新安装“概率包”

Answer 2

首先，尝试重新安装损坏的包，如提示符，用。

sudo apt-get install --reinstall libavahi-glib1